RollSeal RS-500 Installationshandbuch PDF herunterladen (Seite 41)

Part No 4801-5154 Rev 01-2015 RS-500/600 Series Doors Page 41

27 Operation of RS-500/600 Series with Manaras Motor Option.

Complete installation and operating instructions are provided with the Manaras Operator at the time of delivery.

Refer to these instructions for the proper installation and alignment of the Manaras operator.

After the door has been secured to its frame (as previously described), the Manaras motor has been mounted with

chain, spreader bar and associated hardware (per instructions in this manual and the Manaras installation manual),

the door will be ready to operate after completing the following steps.

27.1 Limit Switches.

There are 4 limit switches. Two are used as end of travel, one is for radio-control or one-button operation and

one is for reversing devices. These switches are activated by the rotary cams traveling on a threaded shaft.

Refer to Diagram 27A, Limit Switches.

Limit Switches

Warning!

TO AVOID THE DANGER OF POSSIBLE DAMAGE TO THE DOOR AND OPERATOR,

TRAVELLING CAMS MUST BE ADJUSTED TO THEIR APPROXIMATE POSITIONS

BEFORE MANUALLY OPERATING THE DOOR OR BEFORE

APPLYING POWER TO THE OPERATOR.

Warning!

Do not remove the cable ties from around the door head unit until the door is installed to the

door frame and the Manaras Operator is properly installed to the door drive shaft. Without

proper support, the door will drop with rapid motion and injury may occur.

Before using the Manaras Operator’s UP/DOWN manual chain or switch controls,

ensure the shipment cable ties and drive shaft safety brackets are removed

from around the door head unit.

“O

en Position” cam

“Close Position” cam

Cam Retaining Plate

“Advanced Close”

Limit Switch

Limit Switches Lever

“Advanced Open”

Limit Switch

“O

en” Limit Switch

“Close” Limit Switch

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 62 63

Keine Kommentare

RollSeal RS-500 Installationshandbuch Seite 41