RollSeal RS-500 Installationshandbuch PDF herunterladen (Seite 21)

Part No 4801-5154 Rev 01-2015 RS-500/600 Series Doors Page 21

13.6 Assembly of Parts

Arrange the horizontal member, left vertical member (left track), and right vertical member (right track) on

the floor in front of the clear opening as shown in Diagram 13D. The curtain side of the horizontal member

and each vertical member faces down.

Diagram 13D

Placement of Parts for Assembly

Lay left track, right track, and horizontal member

face down in front of the clear opening as shown.

End of

horizontal

Member

U-shaped

plate

Plate fits inside

vertical membe

Slide vertical member

over U-shaped plate.

Vertical

Member

Clear Opening

At this end of members

3/8" x 1"

Bolts & nuts

On each end of the horizontal member is a

U-shaped plate that fits inside each

vertical member. The U-shaped plate has

four bolt holes, two on the inside and two

on the outside flanges that match bolt

holes in the vertical member. See diagram

at left.

1. Align the vertical member with the

U-shaped metal plate at end of

horizontal member.

2. Slide the vertical member onto the

outside of the U-shaped metal plate of

the horizontal member as shown in A.

3. Insert bolts through bolt holes as shown

in B. Install nuts. Tighten bolts & nuts

securely.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 62 63

Keine Kommentare

RollSeal RS-500 Installationshandbuch Seite 21