RollSeal RS-500 Installationshandbuch PDF herunterladen (Seite 48)

Page 48 RS-500/600 Series Doors Part No 4801-5154 Rev 01-2015

31 Egress Strap Removal/Re-Installation

31.1 Removal

1. Locate the door controller and turn off the power switch on the left side of the controller.

2. Remove the door’s head unit cover.

3. Place the door in the JOG mode by holding the Up and down arrows on the controller at the same time

until you see “JOG” in the controller’s display.

Warning!

Watch the panel closely while you are slowly jogging/rolling the curtain up on the drive shaft.

Stop when you see the area where the long egress strap is connected to the

short egress piece attached to a triangle panel. This should bring the

strap and connection point, right to the top for easy access.

Failure to stop can cause curtain to reverse direction and damage door components.

4. Find the area where 2 loops are attached with a quick-link, unscrew the quick-link that attaches the long

yellow strap loop to the yellow loop of the triangle piece. Make sure not to drop the weight into the door.

5. Access the inside area of the cooler/freezer box through the door opening. If the strap is hanging inside,

unhook and remove the gold buckle and the damaged yellow strap (top center of door) from the door

31.2 Installation

1. Locate the door controller and turn off the power switch on the left side of the controller.

2. Remove the door head unit cover if it has not been removed previously.

3. Un-roll the yellow egress strap with attached gold buckle.

NOTE: Insert the strap through the hole in the center of the door, near the top, where

original strap was traveling down inside the curtain and replace the old gold

buckle with the new one.

4. Proceed to the outside area and locate the roller assembly at the top center of the door where the original

strap came into the curtain area from the inside cooler/freezer area. Use anything with some stiffness

(banding material) and feed the stiff item through the roller and down through the slot located in the inside

cooler/freezer area and tape or tie it to the small loop (not the D-ring) of the yellow strap. Then gently

pull it through the hole and roller assembly at the top/center of the door.

5. Ensure the yellow strap is not twisted. Place the counter weight onto the yellow strap.

6. Attach the new strap (small loop) that you just pulled into the curtain area to the (small loop) strap on the

traingle piece of panel using the quick-link.

7. Attach the gold buckle to the door frame.

8. With the controller still in JOG mode, use the down arrow to lower the door to the floor. Exit JOG mode

by holding the Up and Down arrows on the controller at the same time until you see “---” in the display of

the controller.

9. Press Open on the 2 button switch. The door should open, timeout, and close. If it does, run it open and

close several times. If it works well then go to step 10. If not, notify tech support of the manufacturer.

10. Re-attach the cover.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 62 63

Keine Kommentare

RollSeal RS-500 Installationshandbuch Seite 48